Discussion Locked

inaccessible boot device error on new hd

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Question: After installing a pre-installed operating system (windows 2000 server)hard drive into new configuration (new motherboard etc...) i get a blue screen of death with "inaccessible boot device..etc.." Anyone ever seen this error, and how do iresolve it without having to reinstall OS. Thanks.

11 replies

by jwilczyn

I?ve had similar problem but with a pre-installed win2000pro. I fixed it by updating BIOS. It has to do something with the Advance Power Manager ? Bios support.
Good luck

by it admin

well I think you can do this try fdisking the harddisk to two partiotns and then format using the format command on the os cd and put back the data

by craig haunch

depends on the previous config. Is it a scsi drive? if it is is the scsi card the same in the new config? wrong drivers for the controller card can cause this problem.
What you can do is if the controller is different, put drive back into old config, load drivers for new controller, then shutdown and transfer into new config. Otherwise it is probably going to have to be a re-install.

by saihib

Basically, you hosed yourself. Two critical drivers that Win2K needs to start are the storage controller driver and the video controller driver and neither of those drivers is correct for the computer you put the hard drive into. Re-format and re-install.

by lafavor_s

You're not totally out of it yet, IF, you still have the first system still available, and you can get the drive to boot properly when you put it back in the old system. You will need to "rollback" the drivers for the IDE interface to the lowest default, IE. standard IDE controller, I also recommend that you do the same with the video drivers. This should take care of the problem, WIN2K should do the autodetect and ask for the drivers that support the new MB.
There is a second and more convoluted approach using the Sysprep utility that is part of the WIN2K package, (I think it has to be installed from the CD) info on how to take this route is available at Microsoft's Technet website, you will want to make a hard copy of the instructions.

This discussion is closed to new replies.