Discussion Locked

indentify sdram voltage and Ns?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have purchased via ebay 3 sticks of sdram. All 3 sticks are NEC 256mb PC133 32*4. -I purchased one from a source with good documentation it is noted as NEC 3.3v 7/7.5ns.- The other two have limited documentation I do not have the specs of the voltage or the ns. I do have documentation that indicates they are both 256 MB NEC 133MHz 32*4.NEC site lists thiese as no longer in production. How nice for them! Please if you can advise I would most appreciate it. Q: How can I identify the voltageand the ns?

3 replies

by danpiers

DIMM modules have two dimples in line with the contacts. Each of these dimples can be in one of three different positions: left, center, and right. If you look closely at the dimples, you will notice that one is centered between the contacts oneither side and the other is closer to one contact than he other. One of the dimple's position indicates the voltage that the DIMM works at. Typically, that voltage is 3.3 volts. If you have a DIMM that is a 5 volt model, it cannot fit in a 3.3 volt socket. Because of this, you really don't have to worry about the correct voltage! If it fits, it IS the right voltage!
As far as the nanoseconds timing goes, most memory chips on DIMMs end in a number. If the number is 10, the module is a PC-66 (or 66MHz) model. Theoretically, this module could run at 100MHz, but anything past 85MHz is probably unstable. If the number is 08, the module is usually a PC-100 (or 100MHz) model. Theoretically, this module could run at 120 MHz, but is onl certified to run at 100MHz. The number on your module is probably 07 or 75. That would typically indicate PC-100 or PC-133 (actually more stable at 100MHz than 133MHz). A better number for a 133MHz module is 06, which theoretically could run at 160MHz, but would be very stable at 133MHz.

by markalink

Thank you so much for this information. I was trying to find documentation such as this and could not find such! I appreciate your time and your answer is very clear and concise! Thanks so much!...markalink

This discussion is closed to new replies.