Initialization String, USR model # 3094

You might want to go to the below URL and download and unzip the driver (in the hope that there's also documentation on this model in the zip).

http://www.usr.com/support/s-modem/s-modem-oem-downloads.asp#3094

USR was bought out by 3COM...but I cannot find anything on their site with this model either.

I believe the initialization for all modems is :
AT
What are you trying to make it do?

It kind of depends on what software you're using.
Here's a couple of strings to try.

InitString=AT&FB0X4&A3&C1&D2&M4&H1&K1&B1S7=60

InitString=AT&F0W2&C1&D3S7=60

The init string is a combination of AT commands and S registers which vary with brand and model. The init string changes with the use (application)IE: Winfax uses a different string then Hyperterm. The AT command set is standard but the S regs can save a configuration to NVRAM. NVRAM has a finate number of write cycles. When write cycles expire it won't accept more writes till the NVRAM is replaced. If you can find the S reg set for your modem you can type an init string for your app. You can also try the S regs for a USR Sportster of comparable speed, might be the same or close enough. Do not include "&W" in an init string that runs often or your NVRAM will expire.

This question was auto closed due to inactivity