4 replies
first check if you have the lastest bios update for the dell.
after the bios upgrade, check if the bios is seeing the full capacity of the harddisk.
you may need to partition the harddisk to see the full capacity.
if those don't help your search should be directed to the manufacturer of the harddisk to help you out, on how to install the harddisk in xp.
Leopold
by dmiles
After checking the BIOS updates,you then will want to check the jumper settings on the drives itself to make sure the first drive is set to master and second as slave.
Open my computer and see if the drive is seen in the panel,if this is the case then it is seen and I am confused as to what you meant by it not being recognized by the master drive
by dmiles
After checking the BIOS updates,you then will want to check the jumper settings on the drives itself to make sure the first drive is set to master and second as slave.
Open my computer and see if the drive is seen in the panel,if this is the case then it is seen and I am confused as to what you meant by it not being recognized by the master drive
by otl
Agree with dmiles, however on the side of my Maxtor HD reads; Drives larger than 137M require Windows XP 2000 SP 3, or higher, Windows XP SP 1, or higher or ATA 133 PCI card. Thus either upgrade XP to at least SP 1 and verify the original HD is not set to Master only HD (CS should be fine) and the new should be set to slave (or CS).
If you used the overlay disk (usually provided by the OEM), rerun Fdisk and format using Win XP. OS on the primary disk will not read the secondary if both are not using the same overlay program.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending