Discussion Locked

installing a cd rom

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I install a different cd rom. I was told to just put it in the computer and it should recognize it. Now I have config errors and missing files. My computer loads into safe mode to do a surface scan now.

5 replies

by thechas

I suspect that there are DOS mode drivers installed for the old CD drive.

From safe mode, go to the run box on the start menu, and run either msconfig, or sysedit.

You want to edit the autoexec.bat and config.sys files to ignor the commands for the old CD drive.
The lines should have the term mscdex in them.

In msconfig, you can uncheck the line to temporarily disable it.

In sysedit, you need to add the term rem with a space after it at the start of the line.
Save the modified files.

You should now be able to boot.

If so, you can go back into the autoexec and config files and remove the lines.

If you need DOS mode access to your CD drive, you will need to install the DOS drivers for the new CD drive.

by watsol

I would check that the jumbers- master and slave were not set the same as any device sharing the same IDE cable. Then if the cdrom is on a cable by it's self I would set it to the master position.

This discussion is closed to new replies.