7 replies
by ebob
Generic Answer:
Buy an (E)IDE hard drive of your requirements. I would guess that you want to make sure that it is ATA33 (not 66/100!). Find an empty disk slot in your case and screw your new HD in place. There should be a ribbon cable going from your Motherboard to your current HD. There should be a connector between these. That's what you want to connect to the large connector on the back of the new HD. Find a spare power (4 pin) connector inside your box and connect that to your HD.
Reboot.
Run FDisk and let it find your new HD. Setup a partition, format it, and you're done.
by nonemc
by bowieb
Adding a hard drive is not particularly difficult. Just follow these steps.
1) Open up your case and make sure there is a place to mount a second hard drive (Your user's manual should also be able to help with this).
2) Purchase an IDE hard drive. Any of them should work fine.
3) Configure your original drive as a master and the new drive as a slave. This is done with jumpers on the hard drive. There should be pictures on the drives showing the correct jumper placement.
4) Mountthe new drive and connect it to the same ribbon cable as the first drive. Don't forget the power connection as well.
5) Start up your computer.
6) Go to a DOS prompt and run FDISK. Switch to the second drive and partition it however you like(Probably just one primary partition using all the space). You will need to reboot after this.
7) Go to a DOS prompt and type 'DIR D:'. You should see an error 'General failure reading drive D'. This indicates that you have the right drive. If you get a directory listing, then something has gone wrong -- Stop here and get help.
8) Type 'format D:'. It will ask if you are sure, answer yes.
9) Once the format is done, you should be able to access your new drive.
NOTE: BE CAREFUL! The FDISK and FORMAT commands can erase your old hard drive if you do not use them correctly. If you are not confidant of your ability to do this, take the computer to someone who can do it for you.
by nonemc
by the scruffy1
by nonemc
by nonemc
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending