Question Locked

Installing a Secondary Hard Drive

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ladies and Gentleman,
What began as a simple procedure turned into a significant undertaking and I am now at a slight loss of ideas. Here is the situation.
I recently purchased a 500GB Internal IDE drive to be installed on my home desktop as a secondary hard drive. I thought it would be relatively simple, but never imagined that the system would not be able to recognize the drive. While the BIOS Setup can see the drive as connected to the Secondary IDE Device, the hard drive is undetectable in Windows XP. It will not show up in Disk Management, and the Device Manager does not recognize the drive either.
After doing some research, it seems that older motherboards may not be able to recognize the large capacity drives such as this one. Western Digital gives a solution to setup the hard drive by explicitly stating the Cylinders, Sectors as much smaller than they actually are THEN running a software tool that will enable the drive. I have not had time to implement this solution yet.

Does anyone have any suggestions/solutions? I'm primarily looking for a device to store my expanding music collection. At one point, Internal drives ran faster than external ones, however, does anyone know whether USB2.0 can run at the same speed as an internal IDE?

Any ideas and hopefully solutions are welcome.

Thanks as always,
Nate

12 replies

by smitty2.0

I just added an older hdd, samsung4002h, to my new PC. Set the jumper to SLAVE. Had no problem with install and bootup. Backed up some old files that I wanted to keep then tried to clean the old hdd and reinstall the same O/S(XP/SP2 boot discs). Got the message "Drive Not formatted, would you like to format now?" Boy! what a mistake! New message says "Drive cannot be formatted". Now I can't get it to format nor can I gain access to the old hdd. What do I need to do to make this drive so I can save files there for storage?

by rkuhn040172

Run just fine for things like music.

I keep my collection on a 300 GB external via USB for archiving and playing and am quite happy.

by natelanman

Hi Rick,
Hey, I should have mentioned before that I infact have a 320GB External Western Digital USB 2.0 Drive which runs great. If I simply can NOT connect the Internal 500GB as a Secondary Primary Drive, I will simply buy an enclosure and run it that way. The geek in me however says that I must get it to work internally and thus this is not an adequate solution! :)

by joe v.

That does not answer the question. I too have external hard drives, but thats "beside the point".

by joe v.

I installed a second hard drive (WD 500 G)on my 3 year old Dell PC for the very same reason, connected per manufactures users manual, booted, and set the drive from "off" to "automatic". But it does not appear on the "my computer" window. Nevertheless, I loaded music and videos until my primary drive was full (assuming the second drive would work automatic) but that didn't happen, and I too am at a loss for how to fix it. Hence, I am here. What gives....anybody?

by older mycroft

You are 2.5 years late in adding your gripe onto the end of this thread.

I suggest you create your own question.

[b][u]NOTE:[/b][/u] Unless you create your own question, you will fail to receive any email alerts when any peers have submitted a reply.

by older mycroft

You are trying a half-arsed attempt to intimidate a peer who posted over [b]TWO AND A HALF[/b] years ago.

I doubt if he can hear you. ;)

by joe v.

Intimidate? I assume this is a professional forum. I'm simply candid in the way I communicate. I was merely attempting to promt a reply as I assume these forums are here for users (like me) who have problems, questions, and seek useful information, no matter how dated this information may be.

by joe v.

Thank you very much for that information. I did locate the disk and it seems to be compatible with my system and all indications are that the disk is working properly. I suppose that as it is set to work "automatic", it will at some point. However, I want to create a short cut to appear on the "my computer" window (just like my "C" drive) so that I may also use it manually. Can this be done, and if so, How?

by ic-it

Please start your own question. More people will respond to a fresh thread and when the solution is offered, you have the option to mark it as helpful. Then other folks who have a similiar issue will be likely to try that solution and everyone benifits.

This discussion is closed to new replies.