Discussion Locked

Installing an ATA 100 PCI card

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an older Gateway (4sx-33) I am trying to install an ATA 100 PCI card in it to support the 20 Gig. Hard drives and 48x CD rom I have installed in it. When I hook the card up , my system freezes...any suggestions as to what or if I am doing anything wrong?

6 replies

by csmith

The most likely is that the HD and CD-Rom are both set to master or both slave.
Test this by starting only with the HD installed.
(I am assuming that the UDMA 100 is the only active controller in the system.)

The next most likely is the problemof PCI version. (The motherboard is compliant only to an early version of PCI.)
The test here depends on the model of the UDMA 100 controller.
The usual symptoms are a black screen and the Video BIOS not displaying.

The next most likely is a ROM BIOS conflict.
The ROM of the UDMA Controller has to be recognized.
Test: Check the BIOS, also look for the Video BIOS display. Does it display? If yes , then the UDMA Controller BIOS should display next. Does it?

This is a start.
Yes, I agree a Gateway this old is only worth 10 points.

Regards, Chris

by zeus who frags

First, try the method suggested above. See if your motherboard can actually support this card. But be careful, if you succeed, you will encounter other problems. Your bios will not detect such a capacity. You will have to flash it (considering it possible on such an old motherboard). Moreover, if you are under Microsoft systems, you will need Win95 OSR2 to format your disk in Fat32 if you don't want to cut your hard disk in 10 partitions of 2Go ! And I wonder if Win95 OSR2 will work on an sx33.Finally, if really nothing work, maybe the PCI card if too new to be plugged on a sx33. See, even the most powerful PCs don't really need ATA100 because they are not enough powerful! So, imagine on sx33...

Good luck.

This discussion is closed to new replies.