Discussion Locked

installing circuit boards

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

what would you do to set the Adaptec AHA-1542 SCSI host adapter I/O port base address to 230h?

1.- set DIP switches 6 and 8 to 0 and switch 7 to 1
2.- set DIP switches 2 and 4 to 0 and switch 3 to 1
3.- set DIP switches 2 and 4 to 1 and switch 3 to 0
4.- run the software configuration program.

7 replies

by lo

Hi - I don't / haven't played with SCSI too much but ... I conneceted a SIIG some time back, have an Adaptec 29* but haven't hooked it up yet.

What is it you are trying to accomplish or is the answer to this 'obvious' to those that are up to their necks in SCSI?

by cascom

First you need to identify which 1542 board you have. there were a number released and the identifier is on the BIOS EPROM on the board.
Assuming it has jumpers to control the settings, use the settings appropriate for your particular board.
You have listed all the possibilities from the various manuals, you need to find out which board you have before proceeding.

This discussion is closed to new replies.