Discussion Locked

Installing hard drive

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I attempted to install a Maxtor 7200rpm 40 Gb drive but my system refuses to recognize its presence. The processor is an AMD-K6 2/400Hz.

13 replies

by darts32

Check the jumper settings on the HD. If you system supports it you can set it on cable select. If not then use master for one HD and slave if it is the second HD in the system.

It could also be the cable or your system does not support the 7200rpm drive. Check for a bios update for your motherboard.

Start with these options and comment back if it still does not work.

by jramos

Check the bus speed of the HD (ATA66, 100, 133) That is most likely your problem. You will need a BIOS upgrade or a new Motherboard.

by thechas

Some mother boards and some hard drives do not work well together.

Have you tried having just the new drive connected and jumpered for single drive?

If the drive is still not detected, your best option is to buy a PCI slot IDE controller card.

For under $30, not only will the new drive be recognized, but you will get the full ATA100 or ATA133 data transfer rate.

Chas

by egsiegmund

Although I did not try a PCI Controller card that probably would have solved my proble also. I upgraded my BIOS from the mfr. to solve the problem.

by rebelyuz

check the jumper settings,then boot, goto setup set the primary master to 'auto',so that it will automatically detect when you boot then exit setup.or you could set it as 'user' then go to ide hard disk detection(still on setup),and detect the hd manually.

by opatzg9

you pretty much have all the answers here. Chas' keeps recommending cards and that probably is the best answer and most solid fix. older machines/motherboards just don't support the larger drives. My AMD900 wouldn't support the 80 gig drive I bought but the drive mastering software allowed it to work. Good or bad option? don't know yet but the pci ide card would definitely fix the problem for you.
Good Luck!

by egsiegmund

The PCI Controller card probably would have helped but upgrading the BIOS did the trick.

This discussion is closed to new replies.