Discussion Locked

installing M-Board

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
M-board P4Te Assus, when installing the board into the case which screws should have insulations, for not shorting the board with the chassis (Grnd)

5 replies

by thechas

There are a number of opinions on this.

What I do, is look at the board. If the circuit pattern around the screw holes looks like a star-type lockwasher, or there is a large gap between the circuit pattern and the hole, I use normal screws without insulating washers.

The design of motherboards has improved since the early days of the PC when the circuit board designers were not allowing trace clearance around the mounting holes.

I have not personally seen a motherboard that required any screw holes to be isolated since the 486 days.

Chas

by cbach1997

Motherboards have been designed for some time to not require insulation washers on each screw, the metal ring itself is isolated from any sensitive components. However, if you have them around, feel free to use them anyway, they'll unscrew easier later. Many times the brass risers/spacers that screw to the case (which the board sits on) has the same thread as computer case/hard drive screws. So just use screws with a standard flare and you should be fine.

Hope this helps,
Cbach1997@hotmail.com

This discussion is closed to new replies.