Discussion Locked

installing memory

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed memory. When I hooked everything back up I turned on computer,I got an error message not all memory install I had 64 on side 256 on the other. I installed another 256 . The startup show the numbers installing ram 504 ram installed. What should I do? I own a compaq model #7470 amd-k6 chip

7 replies

by hughesm1

It may be a compatibility issue. Make sure all the RAM modules are the same flavour (SDRAM). Try installing the 256 sticks in the first two slots, then the 64 in the 3rd. Or, if you really don't need the 64MB stick, don't install it and see how it comes up with 512MB.

by thechas

If you are running W98 or Me, I recommend that you return the new 256MB module.

Why? Windows 9X has a bug, and in many configurations refuses to boot up or crashes with more than 511MB of ram.

As to why you are getting errors on the post for the new ram, many motherboards require that the largest ram modules be installed in the first slots, and the smallest in the last slot.

I have also seen motherboards that have "unusual" limits on installing RAM.
On 1 board, if more than 32MB was in either of the first 2 slots, the 3rd slot was disabled.

I also agree with answer 1. Many times different DIMMs do not work together.

Chas

by d_v ant

If you have two 256 chips installed and the PC is only showing 504, I would have to assume that 8MB is being assigned to your video card. I have a PC at my house that behaves this way. It has an integrated 8 MB video card. The BIOS assigns the videomemory and then shows me how much is left.

Hope this helps.....

This discussion is closed to new replies.