Discussion Locked

Installing new HDD in a Compaq Deskpro

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have Deskpro 5233 (MMX) with a 3.2Gb drive. I have been attempting to install a 8.4 Gb drive as the master. I pulled the new drive from my old Compaq Deskpro 575. The 5233 BIOS initially did not recognise the new drive (configuration) until I installed a later Rompaq, however once recognised, it then didn't recognise the diagniostics partition. I am now trying a complete rebuild of the new HDD but need a bootable floppy that can read the CD. Have tried Compaqs own Sony CD drivers to build thefloppy, no success. The new drive was partitioned as C & D and I would really like to retain the D partition if at all possible without a total rebuild.

Errol Ross

7 replies

by tbradley

Borrow a win98 boot disk, it contains generic CD drivers that will recognize just about all CD roms. Select the second menu choice, boot Computer with CD rom support.

If you can't borrow or find a 98 boot disk, you can download one from bootdisk.com

by acosgrove

If you have a computer that is running Win 98 or if you can put the old HDD back in and boot win 98, create a win 98 startup disk from the control panel -> add/remove programs. From there go to the Startup Disk tab and click the button that says Create Disk. This disk will recongnize most if not all IDE/ATAPI CD-Rom drives.

Good Luck

by karimchaq

pay close attention to compaq own small partition to boot the hard drive. the cmos information is in this small partition in the hd.

This discussion is closed to new replies.