Installing USB Cable - Parallel Printer
Cable drivers installed correctly but when setting up printer port ATENUC 1284B ON LPT2
Win 98 shutsdown and also dont restart with cable plugged in, anyone experienced same problem?
Hardware
Cable drivers installed correctly but when setting up printer port ATENUC 1284B ON LPT2
Win 98 shutsdown and also dont restart with cable plugged in, anyone experienced same problem?
by bertievn
by lejer
I'm going to have to make some assumptions here.
You are trying to connect your printer with a USB cable and it is still recognizing your LPT-2 Parallel Port.
Disconnect both or either printer cable > Go to Device Manager > Remove your printerand USB > Reboot and let your computer find its USB port drivers and install them > Plug in the printer with its USB cable only.
It may or may not self initialize. You may have to go to:
My Computer > Control Panel > Printers > Add Printer (make sure you load only the printer's USB drivers)
If your printer continues to see LPT-2 then you will have to locate and manually delete the printer drivers for the parallel port.
There is also the possibility that you will have to go into your BIOS and enable your USB.
Hope This Helps
LeJer
by bertievn
by bertievn
This discussion is closed to new replies.
Sort by Trending