Discussion Locked

Installing Video Card

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an old PC with an unknown motherboard that has onboard video. The driver for the video adapter is not available and the only setting that I can get is VGA and 16 colors. I decided to order a Matrox Millennium II 4MB PCI card. When I install the card and boot the PC the card is found and the driver is loaded. However, the Device manager shows that the card is not working because I cannot have two video adapters on my PC. Is there a way to disable the onboard video adapter so I can use the new Matrox card?

9 replies

by maxwell edison

There is either a BIOS setting or a motherboard jumper to disable the on-board video. Most likely, there will be a BIOS setting.

Reboot the computer and enter the BIOS - most likely by pressing the Delete Key. In the Advanced BIOS features (or something similar, depending on your exact BIOS) there will be a disable/enable on-board video.

Good luck,

Maxwell

by tnturner.com

You have to go into the cmos and shutdown the onboard video when you boot up the machine try hitting the delete key to enter cmos right when you start the boot sequence if it is ami bios or try ctrl-alt del, esc key, ctrl-alt-esc,f2, f10, f1 or if sony try f3. and shut down onboard video.Hope this helps

by gwr24hrs

depending on the manufacturer there will or will not be a bio's or jumper setting. would help to know who constructed, but if all else fails try disabling the primary.

by thobert

if you are going to have to deal with this board to any great extent you should get a manual. you first have to find the maker. i use the FCC ID # to find the manufacturer and then see if drivers and manuals are available. http://www.fcc.gov/oet/fccid/
good luck.

This discussion is closed to new replies.