Discussion Locked

Installing Win98 with new Abit KT7A MB

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just built a new AMD 1200 Mhz 266 FSB on a Abit Kt7a Board. When I install Win98 the copy process works fine intil windows starts to find PNP hardware and set up the windows enviroment. As it starts to finish the install it tells me that "runonce" has caused and error. I can go on from here but then I get "can not flush registry" and the system stops at a dos screen. I close the dos screen and windows brings up the start menu with the windows setup screen behind. I then restart the system and windows the set up the control panel and etc. All seems fine until I run system file checker and then it tells me I have corupt files. I fix the files and then go on installing the video and the like. Then not to long after that the computertells me that (usually) a rundll32 error at kernel32. At this point it is worthless to try and go on with the system. The latest error that I am getting is EMM386.exe a memory module #### and the system has halted. Any ides on this would be helpful.

Ps. I have used other systems with the same hard drive and have been able to get clean WIN98 installs with no problems.

9 replies

by richard_barsby

Hi when we install on a system which has removable cards ie sound,network,modem we always install with the minimum fitted ie
Main board
Memory if more than 1 dimm only one of them
Video card
HDD
CDROM
Floppy
This way we can find which card/drivers cause the problem. Yours maybe by the sound of it be a duff DIMM this very often upsets windows installation.

Hope this helps

Rich

by dmiles

Sounds like a timing error when loading windows on a AMD processor over 500mhz,check the AMD web site,use search to locate problems loading windows,also it is listed in Microsoft knowledgebase,if this is the case then a fix is also listed.
The process starts with switching the jumpers on the motherboard to slow the timing and after loading windows you can change the jumpers back.

by katlynnc

Was very help ful except I was not able to find the information on the differt web sites.

by montea7

Set your bus speed in the SoftMenu to 100 then do your install. After installation go back into the SoftMenu and set bus speed back to 133.

by csmith

In the BIOS settings make sure CAS Latency is set to 3 (Not 2)
Also check for a noisy Power Supply.
Yes, this is a Memory problem.
The HD is OK.

by katlynnc

This was the best of the group. I aslo had to flash the bios to get a clean install. This is the first full day this computer has been running with out any erros.

This discussion is closed to new replies.