Question Locked

Installing XP

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had a faulty PSU and replaced yet my computer still kept shutting down. I decided to rebuild.
New motherboard, processor, hardrive and RAM. I am having problems installing XP. I either get a stop error message or if I get to the install, the compuetr shuts down in the middle of the install, as it did before I replaced everything. All hardware is new and working, and conected properly and compatable to my knowlege. I am stumped and frustrated,. Anyone have any ideas?

10 replies

by older mycroft

What is the error message?

You didn't say if you had replaced the optical drive?

Usually a shut down after some minutes can be down to a problem with heat. How well ventilated is your case. Is it a new case. If not maybe you're getting the same heat problem as before.

Please re-post with more info.

by flairtender72

It is the same old case, however I did add a second fan to the case. I have tried this install with 2 different hard drives and 2 different RAM's, same result.
I did install a DVD burner as well.
As far as compatibility here are specs of the hardware:
MBD: MSI Micro ATX Intel
Processesor: Pentium 4 3.2 Ghz, single core
Hard drive: Western Digital 250G
RAM: Gskill 1gb DDR2 667

by thechas

When I have had this kind of problem on a new system install of XP, it is usually a RAM compatibility problem.

Make sure that you have the correct type and speed RAM. Then, try RAM from a different manufacture. Some motherboard manufactures list compatible RAM.

The next most often cause is a mis-clocked CPU. I've seen problems from both overclocking and underclocking various CPUs.

Next, is a PCI card that creates a resource conflict in the slot it is in. If possible, remove all plug-in cards and see if XP installs. Then, install the cards 1 at a time.

Finally, just because all of your hardware is new, it does not mean that you might not have a hardware problem.

Chas

by flairtender72

The RAM that i installed meats the standard for the motherboard. I did try the install with another RAM. I actually got farther with the install with the second RAM, no error messages, but then it shut down. There are no plug in cards. Most is built into the MBD.
Not sure I understand about the clocking problem, advise. Thanks!

by thechas

Theoretically, if the CPU you have is properly supported by the motherboard, the BIOS should set the Front Side Bus and the clock multiplier correctly.

However, sometimes, the BIOS does not get it right resulting in the CPU running too fast or too slow.

If you know the CPU specifications, you should be able to watch the POST screens and verify that the BIOS has it right. Or, enter BIOS setup and make sure that the settings are correct.

There are still a few motherboards where you need to set jumpers for the CPU clock speeds.

Another thing that can go wrong, is if the CPU has say a 400 MHz Front Side Bus, and the slowest speed that the motherboard supports is 533 MHz, the CPU may work some of the time, but will be apt to overheat and shut down.

Chas

by Former member

If you are re-installing on your old harddrives and the computer keeps on locking down, this could be due to heat, like "Old Mycroft" said in his post. You could try this:
Open your case (and leave it open) then try and reload the software, any more problems put down on paper then repost them onto this forum.

by flairtender72

I pretty much have been doing the installs with the case open. I have a second fan on the case as well.

by pandianec

Hi,

this is the common problem i faced lot this kind of problems. i thing u being interrupted by blue dump error to avoid it by clean the MBD and RAM.

This discussion is closed to new replies.