Question Locked

Intel Mother D975xbx2. , Can't add either a Pata or a Sata drive to system

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Raid5 working on Matrix (black connectors)Trying to add a single sata drive. Tried red connector. NG. How do I add a Sata drive or drives? Part 2 of my problem. Using slave IDE port for dvd. Works OK. Tried to add a Pata drive as Master and system hangs with message "hall.dll missing or corruped". Would like to use Pata as a data drive only. That is contine to boot from Raid5 "C" drive. What must I do to add this drive? I did tell the BIOS to use it. Op system Vista, Duo2. Appreciate any advice.Gerry

4 replies

by hal 9000

If you add it as the Master the computer will think that it is the Boot Drive or at least the drive with the directions to the Boot Files and since they are not on the HDD it will not boot.

Col

by gharriso

Will try after I check to make sure I have the latest drivers and CMOS. The cables are very tight and I must remove both drives to interchange them. Will try if newer drivers don't help. Also still hunting on the Intel site for information on how to configure the eight Sata connectors. The manual gave me enough info to connect three HD,s as Raid 5, but not much help on adding a Sata standalone or if two Raid configuration can co-exist. Thanks for yous sugestion.

by hal 9000

As I'm not sure how the 975 Boards work when you have instigates any form of RAID Array.

I've previously had all SATA Connectors used as stand alone drives but I've never attempted to add to a RAID Array probably because I always build too big and have never as yet run into that problem.

But at a Guess I would say that there is something in the RAID Setup before the system boots which if I remember correctly is [b]CTRL A[/b] to get into the setup option after POST.

I hope that is of some help though I'm personally not sure one way or the other.

Col

This discussion is closed to new replies.