Discussion Locked

Intellimouse Optical with3.1 set up Disc

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I run the set up disc and the program starts fine with an icon in the tray.Then after a couple of boot up the icon is gone even if the show icon box is checked.When the icon is not in the tray the mouse doesn't work right. Thank You Charles Gilleanclgillean@jps.net

11 replies

by leo1020

There are many different types of these devices. Most of them work fine; however, first uninstall the software and completely remove all of folders connected to this mouse. Turn your computer off and connect your other mouse. Then reboot your system. Install the software, replace the wireless mouse, turn the computer off and reboot. If this doesn't correct the problem take it back and buy a Logitech Cordless Mouse. Good Luck!

by clg66

I have a corded Intellimouse Optical with 3.1 install disc. I have already uninstalled and reinstalled 4 or 5 times. Thanks for the effort.
Charles L Gillean

by chaosad

I have the same mouse with similar problems and what I ended up doing was go into device manager and remove all deevices under the mouse icon until there is no mouse available and then using the key board to install the driver. And also if yours hasusb ports you may have to install them cause they arent always installed. Give this a shot and good luck. If this dont work at first then do it without restarting.

by wsaverill

I have this same mouse and have never had this problem. I have it connected by the PS/2 connector, and updated the drivers to version 3.2. If you use the USB connection, that maybe your problem. Also check for the file "Point32.exe" under startup menu on the system configuration utility. This is the mouse controller program.

by shanghai sam

ANSWER NUMBER 3 SOLOVED MY PROBLEM. I had to down load 3.2 and it seems to work fine.
Thank You Clgillean@jps.net

by shanghai sam

ANSWER NUMBER 3 SOLOVED MY PROBLEM. I had to down load 3.2 and it seems to work fine.
Thank You Clgillean@jps.net

This discussion is closed to new replies.