Richards explaination appears to be the most likely reason for this happening (except the process of degaussing actually equalises the magnetic field, which removes discolouration caused my magnetic inteference, such as a nearby speaker) This should only happen when the monitor is first switched on, or when the degauss button is pressed, but a dry solder joint in the degauss cuircit could also cause this (cheap). It could also be a couple of other things that immediately spring to mind, such as the CRT 'flashing over' (expensive, probably cheaper to buy a new monitor) or a faulty flyback transformer causing the G2 voltage to surge (essentially turning the brightness full on, causing the safty cuitcits to switch the monitor off and degauss when it comes back on [equally expensive])
In my opinion it is a hardware fault, so my suggestion would be to take it to your local tv repairman for a quick once over. If it's not dry joints, then you could put up with it, but the monitor will die sooner or later
I know you probably didn't want to hear there would be a cost involved, but unfortunatly, it kinda looks like there will be
Hope that all makes sense
Skutts