Just a side note here, Jaqui has it right that a "true" AT system uses a hard physical power switch.
Some AT style systems have dual mode AT/ATX motherboards.
If your motherboard has both the AT style in-line power jacks and the double row ATX style power jack, you can switch over to ATX mode operation.
NOTE: The following ONLY works for motherboards that have both AT and ATX power connections. These are typically in super socket 7, slot 1, and socket 370 baby AT motherboards.
CAUTION: This upgrade involves removing and changing wires that carry AC power!
Make sure the power cord is NOT plugged in while performing this upgrade!!!
You will need:
ATX power supply.
Replacement ATX style momentary power switch.
Motherboard manual.
Unplug the power cord, and then remove both the AT power supply and the power switch.
Install the ATX power supply, and the new power switch.
Check the motherboard manual, and wire the 2 leads from the momentary switch to the proper pins on the motherboard.
Move the power setting jumper(s) as needed to enable ATX mode.
Boot up and enter BIOS setup.
Enable ACPI and power management settings as required for ATX mode.
Chas