Discussion Locked

Is HDD worth repairing

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a maxtor 160gig hdd. It spins up, however the system does not see it. Should I replace the circuit board? If so, where can one be purchased?

5 replies

by dmiles

Did not locate any info on replacing hard drive parts,it would me probaly be more easily to purchase a new drive.

Hard to give up that large drive,it breaks too

by jschein

Thumbs down on replacing the circuit board. It's either a bad board or most likely unaligned heads causing the system to not identify the drive or do anything with it.

More cost effective these days to remove and replace the entire drive. Only time you want to try and re-construct a drive is if it has sensitive data you need to try and recover. That is up to you.

Good luck.

by a

Chuck it dude. It's a paperweight. Or better yet, take out one of the platters and make a nice little wall clock out of it... the mirror finish always looks cool in a computer den.

*IF* you can find a circuit board, it's a ROYAL pain in the tail to replace, and that's not to say it's even the problem to start with.

160gigs is a standard size, how old is it? you might call to see if still has a warranty. Even some OEMs have a year or more warranty.

In replacement, I'd say get a Western Digital. You'll pay more, but a 5 year warranty and higher quality construction is worth the extra few bucks.

A

This discussion is closed to new replies.