Question Locked

is my motherboard fried? thoughts please

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

from this information could any of you tell me (with certainty) if my mobo is fried?:

-when i power on the computer i don't get a picture but I DO get a continuous single beep (separated by 5-6 secs of silence).
-Upon inspecting the RAM there were 3 gold connectors which were charred (and corresponding charring in their dimm (?) positions).
-my video card's fan turns on when i power on.

that is all I can think to include. I am just trying to figure if the mobo is fried, the RAM is fried, or both.

Apologies for the crude description, hope someone can make some sense of this!

8 replies

by mjd420nova

Charring is not a good sign unless you like you sirloin well done. It would be possible to clean the connector on the MOBO and replace the memory, but that's not a positive cure, the MOBO could be fried. If cleaning of one connector helps, cleaning the rest could restore operation, but replacement of the connectors is required. This all depends on what actually got fried, the memory or the buffer chips on the MOBO. Good luck.

by why me worry?

Take a good whiff of the motherboard and if it smells like burned plastic, then most likely it is fried and needs to be tossed out and replaced.

by pomerleau

well, it never smelt burnt.. which kinda sucks. almost wish it had just went up in flames, that way i would at least have a cool story. instead i'm looking at 2 minor, minor charred gold pieces thinking there is no way THIS killed my pc.

i remember exactly when it stopped working. it got stuck at the "checking NVRAM..." screen. naturally, (the barbarian i am) I got frustrated. i whacked it, shut it down and tried to startup again. this time i didn't even get a screen. serves me right i suppose haha..... ugh.

anyway. there are 2 slots for the same type of RAM. should i bother trying a new stick in the uncharred dimm?

thanks for the responses, by the way

by dawgit

You could tell us what kind of Computer (and, hopefully, what motherboard) it is. Why was it checking the RAM in the first place? Did it give you any kind of notice? (as to why it was doing that?) Is your computer set to do a remote start-up?(wake-on-LAN) (If so, There could be problems in that area.) -d

by thechas

First, yes, it is safe to conclude that your motherboard and RAM modules are fried. While it might be possible to clean the contacts on the motherboard, their is a high probability of other damage on the motherboard.

Question 1, did this system ever work?

If it used to work as configured, look at the cylindrical capacitors near the CPU socket. If any of them are bulging or show signs of leaking liquid, you are the victim of either a capacitor failure or a voltage surge.

If you do suspect a voltage surge, I would not try to do anything with this hardware other than to recover your data from the hard drive.

Question 2, if this is a new build system, is the RAM the correct RAM for the motherboard?

Burnt connector pins suggest that a wrong device type was used. Or, it was plugged in wrong. While unusual, it is also possible that there were bent pins in the DIMM socket.

With this level of catastrophic failure, ALL of the hardware in the system is now suspect. You risk at a minimum, a short service life if you reuse any hardware from this system.

Chas

by pomerleau

thx for the tip, capacitors seemes to be okay tho. dunno much about voltage surges but i guess it's possible. ive been using this system for 5 years plus without any real problems until now. ill just consider it as a tip from God, telling me to either 1)get a new comp or 2) get a life!

ill salvage etc. thanks again.

by thechas

At work, we run a lot of systems 24/7. After a few years, the fans in the cheap power supplies start to fail. We are still running systems that predate DOS and the IBM PC.

That said, I suspect that your power supply had a major hickup that sent a voltage spike through the motherboard and onto the RAM.

As I stated in my previous post, all I would try to salvage from this system would be my data files.

Chas

This discussion is closed to new replies.