Discussion Locked

Kt7Raid

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Want to connect 2 30Gig ATA100 7200rpm to Ide channel 3 master & slave also my udma66 13 Gig to Ide 4 CDr to Ide 1 CDRW to Ide 2 DVD to Ide 2 as slave Do not want to use Raid array. Can I still boot from one of the drives in Ide 3?
My sys 1 gig Athlon- Radeon 64meg ddr vivo - 524Meg 133 memory Intake and outtake large Case Fans as well as the cooler on cpu (home built machine) 13 gig Hardrive ata66 is Windows ME and full of programs

6 replies

by computechie

I'm pretty sure that to boot, the boot drive is going to have to be the Master drive on the first controller. When your machine boots, the BIOS looks for the Master Boot Record on this drive, then hands over the machine to the operating system. You can have another operating system on a drive that isn't the master on the first controller, but the info is still contained on that first drive. I hope this helps you out.

by montea7

Yes, be sure to set ATA100 as boot in bios and enter the raid bios with ctrl+h when prompted in order to set the boot drive and udma mode.

by montea7

One note, if you are using 3 dimms and have problems booting or strange problems in general...try removing one dimm. The KT7 has been known to have problems when all the dimms are populated, it doesn't happen all the time but it does happen.

by askerr

True I did have problems , removed 3rd Memory module computer speeded up? Benchmarking before and after proved the case. Thank you for your reply Much appreciated

This discussion is closed to new replies.