Power Loads are what you need.
I am assuming that this noebook uses an external power supply.
(testing internal power supplies in a laptop is difficult)
The power supply should list the different output voltages and either current or wattage.
You then need to create a resistive load for each supply.
75% of rated current output is enough to test the supply.
Let's say the supply provides 5 Volts DC at 3 Amps
5 volts * 3 amps = 15 watts.
We want to test the supply at 75% of ratedcurrent, so we need a 2.25 Amp load
R = Volts / Amps, so we need a 2.22 Ohm 12 Watt (2 ohms to 2.25 ohms at 15 watts or more is fine) load to connect across the 5 volt + and ground lines.
The loaded output should be at least 90% of the rated output voltage, or 4.5 Volts for a 5 volt supply.
Do the same for each voltage the power supply provides.
Unless rated otherwise, the power supply should provide the correct voltages with all outputs loaded to 75% of their rated current.
Chas