Discussion Locked

laptop hardisk controller error

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i am getting this error sometimes when i boot up my mp-975 laptop. BUT, if i hold down the top right hand corner it will boot up.
My question is: Does the controller on the motherboard need to be fixed or could it be the adapter that it connects toin the harddrive case.?

5 replies

by ntoz

I highly doubt that by holding down one side is making your controler work. I would bet money that its a loose connection. Laptops generaly dont have cables. The harddrive pops into a slotted connnection. If you bumpted it hard enough, it could be loose, by holding down the edge your making enough contact to get it going. I would get it fixed or fix it now before you use it anymore. If you get poor connections while writing data, you can corrupt the information on the drive and you will loose your data possibly. It prob a five minue job once you open it up. Many laptops have easy access to get to the hard drive so you can use more then one, look to your manuel for support, if its easy, do it your self.

pete

by buffalodan

The controller is actually part of the Hard drive assembly itself.

IDE stands for intelligent drive electronics, and this standard, since it's inception, has always included drive controller hardware and firmware integrated onto the drive's printed circuit board. your system board connecter is little more than a pipeline into the computer's system bus.

as for applying pressure to one corner of the case while booting, this to me indicates that the connector between the drive and the systemboard is working itself loose,

I personally would attempt to open the case, re-seat the hdd, and apply a bit of hotglue to the connection to prevent it's shifting again in the future.

If you are not comfortable with opening your laptop, (they can be very complicated!!!) then I recommend locating an experienced technician, and asking them to do the repair for you.

Best of luck, i hope this helps...

This discussion is closed to new replies.