1 reply
by squeech
Here's a step-by-step way to get to the 1695CDT HDD. Unfortunately this model requires removal of the keyboard plate.
-Unplug AC power cord, remove internal battery
-Turn machine over and remove the three screws in the middle labeled with a "K" on the bottom of the case. This secures the keyboard.
-Next, remove the cover on top of the keyboard that says Satellite on the right and has all the functions written on it beginning with ON light on the left. Easiest way to do this is to open the LCD wide open and pry gently around this cover. It will pop off. The cover encases the "ON" button.
-Next, remove 4 screws on the top holding down the keyboard. Lift the board up and out towards the top of the unit to disengage.
-Next,two screws hold the hard drive in. Unscrew and pull the hard drive to the right with the little grab extention that will be obvious. Make sure the blue (or gray) plastic thin cover that sits between the right side of the keyboard and the unit gets placed back to where you see it. It just sits there like insulator between the keyboard and the machine itself.
Hope this is easy enough to follow.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending