Discussion Locked

Laser printer for a dusty warehouse?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Not sure if I'm posting this under the right topic but here it goes. Our software developers are preparing a new pull slip report for our warehouse that will print on two sides of the paper. Now they want to set up 2 laser printers in our dusty warehouse to print them on. I was looking at the HP LaserJet 2200 DN which looks like it could do the job, but I'm just nervous about the dusty conditions out there. Does anyone have any better suggestions for such an environment?

Thanks!
Ron

9 replies

by armour

Not much out ther can truly handle this if its mostly settling dust you can box it in on all sides and leave enough room for air flow If its extreamy bad It may require a compleatly enclosed cabinate Witch means opening a door every time to retrive the sheets They have venting with filters I dont have the modles handy but I you require them just e-mail me and I'll sent them on to you

by tocolote

They make "acoustical enclosures" that will help with what you're trying to do.

Check with outfits like Global Computer Supplies, www.globalcomputer.com or somebody like that.

They cut down on 80% of the dust while the cover is closed. They're cheap (relative)and easy to use.

Otherwise you'll have to go to an industrial source which is pretty expensive.

by tocolote

They make "acoustical enclosures" that will help with what you're trying to do.

Check with outfits like Global Computer Supplies, www.globalcomputer.com or somebody like that.

They cut down on 80% of the dust while the cover is closed. They're cheap (relative)and easy to use.

Otherwise you'll have to go to an industrial source which is pretty expensive.

by lafavor_s

If all that you need for the reports is text only, then besides the enclosure, why not think of a older model laser printer that you can pickup reasonably cheap. An HP IIID (at 300 DPI) with an ethernet option, an HP4 series (300-600 DPI) with a duplexer and an ethernet option, or an HP3SI or 4SI, would all be good choices. There are lots of them available, and parts and consumables are also readily available, and drivers aren't a problem either. The IIID or the 4 series would be the best choices as they are the most rugged, and least likely to be bothered by dust.

This discussion is closed to new replies.