Discussion Locked

LCD Monitor - Bad OSD

0 helpful
22 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a monitor that after 30 minutes (give or take a few) the OSD pops up, cycles through all the options until it gets to the RGB screen at which point it continuously cycles through the options on that page. The OSD does not allow you to exit (none of the buttons seem to work when this happens). You can power off the PC, but the monitor will not shut off. When you first power everything up, you can access the OSD and make any adjustments just fine. The hibernation settings are all off, the power scheme for the monitor is set to never. The PC has no floppy drive. It is currently running Windows XP Home Edition. The monitor is a Planar model number PL1700 LCM Flat Panel LCD. Everything works fine except for the OSD as described above. I have gone to Planar's website and there is really nothing there that helped. Any idea's? The monitor was purchased about two months ago. Should I just return it for repair/exchange?

22 replies

by w2ktechman

If you plug another monitor in, does it do similar things?
I would send it in for warranty work myself.

by azul

It could be somthing other than the monitor but I will bet large sums of money it is a bad monitor.

Up untill a year ago I did warranty work for HP/Compaq Dell and Apple, I have seen hundreds of bad displays and based on what you describe, I think it is a bad display.

Have it replaced.

by lcm man

I'm betting that too. But you never know who may know that one little obscure tip or trick. Thanks.

by azul

It could be somthing other than the monitor but I will bet large sums of money it is a bad monitor.

Up untill a year ago I did warranty work for HP/Compaq Dell and Apple, I have seen hundreds of bad displays and based on what you describe, I think it is a bad display.

Have it replaced.

by lcm man

For Sarge: It does it in Safge Mode as well. The video is built into the mother board. The PC is an HP/Compaq dc5000 SFF (Small Form Factor).

by lcm man

For Sarge: It does it in Safe Mode as well. The video is built into the mother board. The PC is an HP/Compaq dc5000 SFF (Small Form Factor).

by lcm man

For Sarge: It does it in Safe Mode as well. The video is built into the mother board. The PC is an HP/Compaq dc5000 SFF (Small Form Factor).

by w2ktechman

If other monitors work fine, but this one does not, the monitor is probably going bad. The best test from here is to plug this bad monitor into another system and see if it still does it. If so it IS the monitor.

by lcm man

Turns out that it is 100% the monitor that is bad. I ruled out sticky switches immediately because it takes awhile before the problem occurs. Thank you everyone.

by lcm man

Turns out that it is 100% the monitor that is bad. I ruled out sticky switches immediately because it takes awhile before the problem occurs. Thank you everyone.

by hal 9000

Well if other monitors work OK on this unit and the monitor does the same thing on different computers you have to be looking at the monitor but I would first be looking at the actual switches on the monitor one is most likely sticking and causing this problem.

If it is repairable or not is a different story though as most of these LCD monitors are throw away items when they break. I had a bad experience with Acer here in AU recently a 6 month old LCD monitor failed and they wanted cash to replace it UG with a different model as the old one was no longer available.

I wish you the best of luck in dealing with this problem.

Col

This discussion is closed to new replies.