Discussion Locked

lcd monitor troubles

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
here's the problem: one of our people uses a two pc setup with one monitor via a kvm switch. all was well till we replaced his 15-inch lcd monitor with a new 17-inch combo lcd pc/tv monitor. the pc with the SiS video chipset works fine, but the pc with the nvidia tnt2-64 is all smeared and fuzzy. both pc's are set at the optimum for this monitor (1280x1024 @ 60hz). no amount of playing with the monitor settings helps. switching back to the old monitor works fine on both, as it did prior. any ideas?

7 replies

by net dude

well i am not sure but, nothing is bad to try.
when you purchased the monitor a cd might came along for driver why not trying installing it on pc which is having problem. and secondly the single pc having problem with the monitor or check the slot for kvm switch.

by net dude

well i am not sure but, nothing is bad to try.
when you purchased the monitor a cd might came along for driver why not trying installing it on pc which is having problem. and secondly the single pc having problem with the monitor or check the slot for kvm switch.

by richard_barsby

Hi if someone there has a digital multimeter get them to measure from pin 1 on the monitor video cable to pin 6.

You may find that the old monitor reads 75R and the new monitor reads a lot higher.

It seems since TFT monitors have been around some manufacturer's do not fit the 75R termination resistors inside the monitor.

You just about get away with this on short cables but by the time you have and extra cable + a KVM you may run into problems.

This discussion is closed to new replies.