Discussion Locked

Lexmark X73 wont print in color

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Lexmark X73 . I have recently bought a color cartridge but it will not print anything in color at all. I have tried several different color cartridges with no printing. It will print in black. I have cleaned the cartridges and the nozles but no help. If anyone knows how I can fix this it would be deeply appreciated.

2 replies

by parvus1202

Cleaning nozles is one of the solutions, but you said it's clean, another is settings, it might be set on draft or b/w printing, next is nozle damage. If you try the first two and still prints b/w, then call Lexmark service.

by kathyjp

Try the simplest stuff first. Check the USB plug in the back of the printer. Sounds silly, but I have a Compac printer where the USB connector that plugged into the printer was too wide to seat fully down into the connection. I had to shave off 1/8" of the plastic to get it to seat properly. If this isn't the problem, go to http://downloads.lexmark.com and click on the utilities link. Get the uninstall clean utility and use it to uninstall the printer and scanner drivers and software. Check (My computer/control panel/add remove hardware) and uninstall anything that came with the printer. Then reinstall from the CDs that came with the printer. Remember to start the install with the printer UnPlugged from the PC. The software install will tell you when to plug the printer in. This should get you printing in color. Then go to the same lexmark site and download the updated driver that is specific to your Operating system. Hope this helps.

This discussion is closed to new replies.