Question Locked

LG r500 Video Card

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

So my Video RAM died on my card the other day so I went about looking for a replacement card for my laptop. And no it is not integrated. Question is, does anybody know if the video RAM is located on the motherboard or the subboard that is above the motherboard?

Thanks in advance,
Travis

7 replies

by herroplz

Yeah that is the correct model. I ran some tests that all pointed to the video ram being bad. Also, I hooked up to an external monitor and got nothing. Now if only I could find a replacement card for the Nvidia Geforce 8600m GS for the LG. Which I have found nothing so far...

by oh smeg

With the same make & Model card to get this working again.

I would however pull the NB apart to make sure that there isn't something that has come loose or got contaminated along the way. Quite often with removable items the Contacts can get dirty and stop working properly or it could simply have been slightly dislodged.

Removing and refitting the card will almost always cure the problem if that is what has happened. Software tests are only good enough to point you to a possible problem after you have first visually inspected the unit.

You could also check the NVidia Site for possible recalls of your Video Chip Set I'm not sure which Chip Sets are affected by NVidia had a entire bunch that where causing problems not so long ago. ;)

Col

by older mycroft

You've 'seen' this daughter-board have you?

Only, in my experience of multiple makes and models of laptop with bespoke mobile graphics 'cards' (both ATI/AMD Radeon-M & Nvidia GeForce-Go), they've invariably had their own RAM but not their own board. They usually co-exist somewhere within the motherboard, usually because the chassis isn't deep enough for mounting a daughter-board.

But if you've physically seen yours then it's clearly different.

Typos

by herroplz

I spent a couple hours last night tearing apart my computer and putting it back together with no luck. The card itself seemed fine and the results were the same when I turned the computer back on.

As for the 8600m series, it seems as if most, if not all, of these cards were effected by bad soldering. I think I'm off to buy a new computer, cause even if I replace it with one of these cards its most likely to die again anyways..

This discussion is closed to new replies.