Discussion Locked

loading windows xp 64 on new sata drive and motherboard?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

my computer will not load xp 64 on new sata drive? any help would be appreciated!

my mother board is an msi k8n-neo4f. I've already tried to load sata drivers from manufacturer.

4 replies

by Former member

You will need another computer to do a floppy.
You will need to put the raid drivers onto the floppy then reinstall your windows, after a little loading you should see (on the bottom of your screen) "F6" if you need to install (or using raid) at this point press on the button marked "F6" when you have done this the software will load a little more then it will ask for your raid drivers at this point put in the floppy and then press "ok" or "next" then follow the on screen insructions. After this your software (Windows) will take to a window of where you would see (or should see) your harddrive(s).
If not get hold of a "IDE" harddrive and load onto this instead once loaded you can do a copy on to your raid drives.

by donaldcoe

I know for a fact XP will recognise any drive irregardless of type and or brand, if the would be onboard controller (whether raid or IDE) is enabled for the feature of selection; that the CD ROM is set as the 1st boot device and above all else that the drive being used is properly jumpered as MASTER and NOT Slave. Normally the Win 2K or XP operating systems has native drivers for drive recognition. I have found from time to time that you may have to disconnect all other drives to prevent ghostly drives or false positives that add to the confusion. Another great setup aid is Partition Magic 8.0 which is a Boot CD and well as a install utility, if PM8 does not see it (the drive) then Windows won't either.

Good Hunting

by memoser

Don't know if this tidbit is helpful or not but honestly, I racked my brain trying to address the issue. Turned out, when trying to verify the jumper settings for master/slave HDD (yet another rathole), the schematic drawing was incorrectly labeled, and reversed the primary/secondary HDD relationship.

by deepsand

Try the "Questions" forum; the "Discussion" forum is for matters of general discussion, not specific problems in search of a solution.

Post problems such as this to the "Question" forum, rather than the "Discussion" forum. There are those who specifically seek out problems in need of a solution, and that's where they go to look for such.

Additionally there are the benefits that:

1) The "Questions" forum provides for your feedback, by way of your being able to mark "helpful" responses as such. This does not necessarily mean that a given response contained the complete solution to your problem, but only that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours, so that they might have a ready source of reference available, thereby perhaps obviating the need for them to repeat questions previously asked and answered.

2) The revised TR makes it quite difficult to find both "Discussions" and "Questions" that have not had a fairly recent post, owing to some functions comingling them in the listings. By keeping each type in their respective forums, it is easier for all to find what they are looking for.

This discussion is closed to new replies.