Discussion Locked

lock-step & interleaving on i840

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Does lock-step and interleaving work on 840 boards with SDRAM via MRH-S repeaters or is lock-step limited to RDRAM? I have a Supermicro PIIIDME ww.supermicro.com/PRODUCT/MotherBoards/840/PIIIDME.htm

It says that interleaving works, and I believe I need all 4 DIMM sockets populated for that. Memory bus is 100 no matter what FSB is. Does this make a theoretical bandwidth of 1.6GB w/SDRAM?

Next, what about lock-step with all 4 DIMMs? Does that allow 3.2GB/s? Or how about 1.6GB/s assuming no interleaving is active. I've read all the Intel tech docs on the 840 and they don't seem to mention anywhere that lock-step is limited to RDRAM (which does 3.2GB/s w/o interleaving.) In fact, I believe the topic is avoided because they don't want anybody to know that you can get such bandwidth from SDRAM with much lower latency--assuming lock-step works.

Any recommended memory benchmarks would be nice too (Sandra crashes.)

5 replies

by Member 26130871

I was at an Intel P4 Launch just today... The Intel Reps I spoke with claim that the 3.2GB/s is possible with EITHER SDRAM or RDRAM. One note, however. Beginning 3Q of 2001, Intel's channel partners will release a $1099 line of PCs with the P4 Processor on a 166Mhz FSB motherboard. I found that interesting. Kind of like putting a Porche engine in a Volkswagon...

by xtrapollis

So Intel says it works with SDRAM--good. I have finally got the latest version of Sandra to work on my board. I get about 440 MB/s which is about what a dual 1GHz gets on an 820 w/RDRAM (so says Sandra.) I got dual 933 w/SDRAM. I tried some mem testutil from Intel and compared it with results that were done at Toms Hardware. My 840 was right up there with RDRAM and DDR, sometimes even beating both of them; at other times, the DDR showed its power. The regular SDRAM boards didn't reach the samelevel.

Well, I guess that's enough proof for me. However, I would gladly take more info if you have some more details that the Intel reps might have given you.

by Member 26130871

I was at an Intel P4 Launch just today... The Intel Reps I spoke with claim that the 3.2GB/s is possible with EITHER SDRAM or RDRAM. One note, however. Beginning 3Q of 2001, Intel's channel partners will release a $1099 line of PCs with the P4 Processor on a 166Mhz FSB motherboard. I found that interesting. Kind of like putting a Porche engine in a Volkswagon...

This discussion is closed to new replies.