Discussion Locked

low level format

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible to damage a hard disk drive by low level formatting? I know someone who has been told many times to replace a hard drive that has returning bad sectors and I know he has llf at least 3 times already and still the bad sectors return.So I ask, is it damaging or not?

5 replies

by alpha-male

The low level format isn't damaging the disk...the disk is already damaged. The Low level format simply isn't fixing the problems that are there. I would salvage the data and replace the drive.

by daz'n'ash

There is no data on the damaged drive. My question is can low level format damage a drive if it is done many times?

by thechas

Low level formatting places no more stress on the drive and magnetic media than writing and erasing files.

Prior to IDE drives, you had to perform a low-level format to the old RLL and MFM drives before you could use them.
For many years, there were not LLF utilities for IDE drives, as the manufactures were concerned with using the wrong utility, and corrupting the file structure.

That is the only real risk for damage, using the wrong utility, and corrupting the file system.

Your bad sectors keep returning because there is damage to the magnetic media on the disk platter.
When you run a LLF, the sector temporarily meets requirements, but after a few R/W cycles, the sector fails.

If you desire to keep using the drive, instead of a LLF, re-partition the drive, and format it with the bad sectors in place. they will be marked as unusable, and, if they are the only bad sectors, no further problems will occour.

Chas

by daz'n'ash

Thanks Chas. It is only a small drive and not worth partitioning. The bad sectors are all over the drive anyway. Time to file it (in the bin).

This discussion is closed to new replies.