Discussion Locked

Low level format.

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The bios of many 486 boards had a low lwvwl format option. I haven't seen this lately, but i have many knackered hard disks of about 1 - 3 GB, which could perform a useful function, but they all have a problem with fdisk or DOS format or bad track zero. Manufacturers wont supply it as they would rather you buy a new one. Where can I get this?

11 replies

by tbradley

The low level format utility you reference was essentially provided for backwards compatibility with MFM and RLL drives that were still around when the 486 were introduced. Too often, they had to be Low leveled to "train" them to recognize new controllers and BIOS calls.

The premier company in Low Level and Data Recovery is Gibson research, which markets Spinrite 5.0. ( www.spinrite.com ).

They hit some hurdles with the introduction of IDE, and the massive changes since then, but depending on your hardware, it might be worthwhile to investigate.

I really wouldn't trust the shareware/freeware utilities, as they are essentially just a GUI interface for the old DOS debug routines which actually perform the Low levels.

by pvp

If the drives are MFM or RLL, I agree--go to SpinRite.

If the drives are IDE, go there anyway--you'll get the explanation of why you can't do this with IDE drives.

Considering the prices of today's drives, I'd just toss 1-3 GB drives. Since you're thinking of low-level formatting, obviously you have no intention of recovering data.

by computab

Cant afford to throw away drives if any good. I now use PC-Check it has a low level formatter.

by nbi computers services

most of todays drives require a manufacture supplied low level program. BUT seagate tools and maxtor had a low level format program that worked on all drives. I have a copy of both of these and since they are small I could email it to you. Contact me at www.nbicomputers.com and leave a msg eather on the support forums page or by email if you would like me to send a copy to you.

by nbi computers services

most of todays drives require a manufacture supplied low level program. BUT seagate tools and maxtor had a low level format program that worked on all drives. I have a copy of both of these and since they are small I could email it to you. Contact me at www.nbicomputers.com and leave a msg eather on the support forums page or by email if you would like me to send a copy to you.

This discussion is closed to new replies.