Discussion Locked

LPT1 Port Not Functioning???

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Please, I need help. I have a Sony laptop computer (PCG-F350). With my printer attached to LPT1, I am unable to print. Also, I run a program that requires a security device be attached to LPT1. However, I am unable to access the program and I amreceiving an error message telling me that no security device is found at LPT1 when in fact there is a security device attached. I think I may have a bad port. Is there a way to fix and/or replace the LPT1 port? And, if so, what steps would be recommended to accomplish such a task?

4 replies

by thechas

If the port is indeed dead, there is no easy fix.

Right click on the my computer icon and select properties.
Click on the device manager tab.
Expand the ports branch.
See if your printer port (lpt1) is listed.
If so, click on properties, and see if it is functioning properly.

If it is not listed, or not functioning properly, check your BIOS setup settings, and make sure that the printer port is enabled, and is set to the correct mode. Depending on the printer it may need to be set toeither bi-directional, or EPP/ECP.

If the port is bad, you have 3 choices;
1. Take the laptop in for repair.
2. Buy a new laptop.
3. Buy a USB to Parallel port cable, and see if that will work for the secrity device. This may not work if the software uses direct hardware calls to read the security device, but is the least expensive way to add a parallel port to a laptop.

Another possability, is that the software for the security device has become corrupted, and has locked up the port.
See if the software mfg can help you verify that it is not a software problem.

You could try printing without the security device attached to see if it is part of the problem.

by fzabin

I followed most of your suggestions and the port is still not appearing to be operational. I do not know anything about BIOS so I was not able to evaluate that. I will probably end up just adding an additional parellel port and use it for everything except the program that requires the security device.

Although I am still not able to utilize the computer the way I want to, I did feel that your suggestions were all valid. Thank you.

by shanghai sam

TheChas, thank you for the detailed explanation.

I clicked on the printer port and properties in Device Manager and it states, "This device is working properly." Yet anything attached to the port is not acknowledged. So I took your advice that the port is "frozen." I uninstalled the program that requires the security device. However, my printer is still not recognized by the port. Is there something that needs to be done to "unfreeze" the port? Also, I did run a test. I connected a new printer to the port and nothing happened. I connected the same new printer to my working computer and it immediately wanted to install new drivers.

Just a little background, this computer was given to me by a friend basically for spare parts, as I have a similar model. She told me that she had a tech look at it and she was told she would have to replace the motherboard for approximatley $1200. So she purchased a new computer instead.

I am a little skeptical at the tech because she also told me that he builds his own systems and was rather insistent that she purchase one of his computers. What steps would I take to determine if it is a problem with the motherboard?

I had already looked into purchasing Quatec's SPP 100, a PCCard single parallel port. But my software mfg (the one with the security device) says the device must be connected to the internal printer port and that it will not be acknowledged if attached to any other parallel ports.

I would really like touse this computer as a backup. There may not be any "easy" fix, but perhaps there's a cheaper one?

This discussion is closed to new replies.