Discussion Locked

Major Hard Drive Hassles!

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 3 machines that are displaying some very strange problems; 2 Win 98 and one Win 2000.

First, the two Win98 machines.
The hard drive in one machine stopped (#1) booting; one of my colleagues moved that drive to another machine, copied offthe vital programs and then reformatted that drive. #2 then "inherited" the same problem (i.e. it would get to the PCI device listing with a blinking cursor and just sit there where you expect "starting win 98" message. This made me think "virus" but I can't find one, even with clean boot disks and latest updates.

Stranger still, if you use HHD #1 in machine #2 and vice versa, they WILL boot, but not when the HDD goes back into it's rightful machine...

Any ideas?

With the Windows 2000machine (#3), it stopped booting; after several reboots, it eventually started loading, but had problems loading the NTFS drivers and had a STOP error. There was another error (which I neglected to write down and have forgotten); phoned someone up and they suggested using the fix utilities on the 2000 CD. No Joy.

Stranger yet, I can't even format the drive; it gets to completely formatted and then says it can't format the drive - and the same with a brand new drive.

I'm mystified!

Any solutions?!

Thanks!

James.

3 replies

by thechas

I suspect an electrical problem with HDD #1.

PC#1 is just more sensitive to the problem.

The bad news is that if I'm right, you may need new MBs, or at least IDE cards to correct the problem.

For PC#3, the first thing I would try would be anew boot floppy. Perhaps, the format command files are corrupt.

The next thing I would check is the RAM.
Loose or failing RAM could be at the root of the problem.

by timthetoolman

Hi,

The other possibility is that you have a CMOS based virus. You could try clearing the CMOS with the appropriate jumper and seeing if that helps.

That would explain why the machine wont boot and also why the problem was transferred to the other PC with the disk...

I would write down the BIOS settings so you can reset them before you did this, though. Also I would try re-flashing the BIOS with the latest version.

Good luck and Cheers,
Tim.

by derekdcosta

Have you tried booting to safe mode on the Win 98 machines?
In trying to list the PCI devices, windows is finding a problem... quite possibly your VGA card drivers or the card itself.
Booting to safe mode (if possible) would load a generic windowsdriver if the Device itself is OK. You would probably find several Graphics Adapters listed in the Device Manager and none of them with the correct drivers for the machine they are being used on at the time.
A lot would depend upon what 'vital programs' were copied onto HD#2.

Just a thought, hope it helps.

This discussion is closed to new replies.