Discussion Locked

Manual SCSI Configurations

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Could someone please explain how you manually configuring SCSI id's for devices, such as hard drives, scanners, cdrom's etc. I am reffering to the jumpers. There is a trick or something to remembers when commiting a device to a specific id.

You may respond to my email address at: Brianingermany@hotmail.com

Thanks

7 replies

by auman

There is no magic there - you just can't have two devices in the chain with the same id - also remember that the last device in the chain must have the terminator jumper installed... - Hope this helps...

by brianingermany

Unfortunately your answer did not help me at all. I am well aware that no two scsi devices may share the same id. My question was based on the configuring of said devices.

by niroopbelliappa

For some of the devices there will be some sort of a button/knob/counter like thing. By manually adjusting this one can set the SCSI id's for devices. But remember that no two devices should have the same id.

by brianingermany

Not enough information given with this answer. My question was in my opinion dealing with configuring or setting the jumpers on the devices. Example no jumper meant device id uses 0, with jumper placed on 1 id becomes 1 etc.

by wlbowers

There are 4 pair of jumpers on the drive. They are either on one end by the supply and cable connector, or on the motherboard of the drive itself. Depending on maufacturer they usually go like this. no jumpers id-0, Jmp pair 1 id-1, Jmp pair 2 id-2,jmp pair 3 id-4. You then utilize two jumpers for the odd number id's. Example jmp pair 1 (id-1) and jmp pair 2 (id-2) is id-3. Make sure of the headers pin numbers before you jumper because there might be more than id on the header. You might find the numbers 1,2,4 silk screened on the circuit board. You can usually get spec sheets for harddrive's from the manufacturers web sites, or from a fax back service. This isfo will be on those.

Hope this helps
Good Luck Lee

by brianingermany

Your information was concise. If interpreted correctly, no jumpers means id 0, jumper placed on 1 indicates id 1, but if jumpers are placed on positions 1 & 2 then id = 3. If I understand that correctly then you have helped me out tremendously.
Thank you for taking the time to really read my question and provide an excellent summory or explanation of id configurations.

Brian

This discussion is closed to new replies.