Discussion Locked

Manual's for hardware devices

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Gateway ALR 7200 SERVER mother board
whis I just purchased and it came without any manuals. I NEED A MANUAL for this mother board. I have gone to the Gateway web site with no avail for my problem.

My problem is that when I turn on the system nothing shoes up on the monitor. (Blank Screen)

9 replies

by ian_c

Did you receive any BIOS/support/utility/driver disks with it? Nowadays many hardware manufacturers include their manuals as pdf files rather than paper copies.

Otherwise, probably phoning Gateway will be the quickest way.

by dmiles

Check the video card if you have one installed.Take out the video card and boot the system.
the other option is that the onboard graphics,could be enabled and their is a conflict with the video card.
Reset the memory and make sure that it is compatible and seated properly on the board

by j_spears

Not sure where to get a manual, and I'm not familiar with this paticular motherboard. Assuming that the board you purchased isn't faulty, then you have a hardware resource conflict.
If the board has on-board video support and your trying to use an add-on video card, you might have to get into the CMOS setup using the on-board, disable it(or switch from AGP to PCI as "Init Display First"), save the CMOS, shutdown, install video board and re-boot with the monitor connected to it.
If the board doesn't have on-board video, then start pulling cards (other than the video card) and reboot until you get a signal. You then need to figure out what the conflict is between the last board you pulled and the video card. Assuming PCI, it most probably is that the card you pulled last requires a non-shared IRQ.
Good luck!

This discussion is closed to new replies.