Question Locked

Master - Slave Management

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had a 40GB WDD with XP in it and want to use as a Slave. I got a 160GB WDD and loaded XP with SP2 on it and want to use it as my Master Drive. The system recognises the Slave but shows it having 7GB only. I tried different configurations explained in WDD site. No luck. Can anybody help

3 replies

by meridenscrafts

Did you check your jumpers?????
Make sure they are in the right place. One is a master and the other a slave, Just reverse them

by ozi eagle

Hi,

As well as setting your jumpers to master / slave, the master drive must be the one at the end of the cable and the slave in the middle. The master terminates the wires in the cable, and if placed inthe middle you may have read / write problems.

Herb

This discussion is closed to new replies.