13 replies
by timwalsh
Need some more information:
What operating system are you using?
Did the slave originally exist as a master on another computer?
If not, how were the programs installed on the slave?
by short4tx
by thechas
1. Both Drives need to be configured properly.
The master will be the C: / boot drive.
The jumpers on the drive must be set for master with slave present.
The slave will be drive D:
The jumpers must be set to slave.
If either drive has multiple logical drives, the remaing drives will follow in sequence.
Then, both drives need to be enabled in BIOS settings.
Next, if the slave is a 'new' drive, it needs to be partitioned and formatted before it can be used.
Check out the information and tutorial links at www.fdisk.com/fdisk
Now, sometimes, drives made by different manufactures do not work well when setup as master and slave.
You may need to try placing the new drive as master or slave on the secondary IDE channel.
Another problem that you may run into with older PCs, is that they cannot recognize some of the new large drives.
Chas
by short4tx
by dmiles
Apparently the system is not setup correctly or the Bios is not recognizing the drive.
Boot computer,at the startup screen press the designated key to to access CMOS configuration panel,check the configuration to see if drive is recognized
To access the drive without going thru the above step,double click my computer,if drive is in the pane,double-click the drive and it should yield the contents of the drive,or use Windows Explorer
by short4tx
by ahriman
by short4tx
by opatzg9
first does bios see both drives? if not then open your case and read the panels on them for the proper jumper pin setup for setting them as slave or master. If they are on the same controller cable then one has to be set master, possibly master with slave, and the other has to be set as slave. The master is the master for that IDE cable. Then you have your primary and secondary ide connections. If one drive is connected to each then they both should probably be masters with any other cdrom or whatever as slave. The jumper pin settings should be on the drives, if it is not go to the website of the manufacturer of the drives and download the specs. Often times right above the jumpers there is a little diagram with MSC for
Master/Slave/?Channelselect?, I've never had a drive work with
?ChannelSelect? (might be cable select) but you can try it if you like. I've always had better luck forcing the drives to behave the way I want.
Good Luck
by short4tx
by woulf
Start at the start. Check the jumper settings. Put the master as slave present and the other as the slave. Cable them,ide (40 pin) drive is master center and slave end of cable, ATA (80pin) the end cable is master and the center slave. Check that they both show up in the bios and are configured and the bios has no limititions on drive size. If all is a go, boot to A drive from startup disk and view them in Fdisk. Both drives should be viewable and partition tables set. If not aprtition and format.
Good luck
by short4tx
by short4tx
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending