Dell shows several different ones for this system so it's impossible to say with any certainly what will fit.
As for the Rating of the Power Supply that is the Max that it can produce not what it produces the M'Board and associated components will only use what is required and not be damaged by the Extra Unused Power that may be available. It's not like you are attempting to feed it with 415 Volts AC on a 110 V AC system the Amperage or Wattage of the Power Supply makes absolutely no difference to how well the M'Board will work unless it is too small when the system will be underpowered and possibly destroy the entire system by overloading the Power Supply.
What you need to look at is the Brand of the Power Supply some are rated to a Continuous Amount of Power that they can produce and others are rated to Peek Levels that they can produce for short periods just like HiFi Audio Systems.
I tend to stick with Brand Name Power Supplies like the Antec ones because they are a Continuous Power Rating not the Peek Variety and have more built into them with better protection of the system than the cheap No Name Power Supplies. Dell will not tell you anything about the internals of your system because they don't want you to realize that they use cheap nasty parts that could all be replaced for far less than the cost of the system and offer no Safety Margin.
A good Power Supply should destroy itself and not hurt the internals of the computer it should act like a Protection Circuit between the Mains and the internal Components, so to that end I only use Antec Power Supplies because I saw the results of a Power Pole coming down and bringing the High Voltage Distribution lines into contact with the Low Voltage Mains Supply so here that means that the 33,000 V Lines came into contact with the 240 V Mains and sent 33,000 Volts over the System destroying everything within the area connected to the mains. In the case of a computer that I was involved with it sent about 3 feet of flame out the Fan Guard and set a curtain on fire but when the Power Supply was replaced the computer worked perfectly again for 3 years till it was replaced with a new one. Not all Power Supply's offer that level of protection and I wouldn't be suggesting that you test them that way either but it's nice to know what is possible.
Many of the Cheap No Name Power Supplies will continue to work after they have sent excess power through the internals and destroyed them and that isn't good for the computer or any attached items. I've seen a Server PS send Mains Voltage into the case and out over the Network Cables destroying the entire network but in that case the Power Supply was faulty but things like that just shouldn't happen and I have never seen this with the better Power Supplies.
As to weather something like this will fit in the case that depends on what you already have in there and how much space is available without knowing which case you have it's impossible to say as well so if I was doing this work I would need to have a look see and then make a suggestion as to what can be done. With Propriety Power Supplies you sometimes need to change the case to be able to get one that will fit and be safe to use.
So as we can not physically see and touch things we can only offer our Best Guess as to things like this.
Col