Discussion Locked

Maximum transmission of RS-232

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Does anyone know the maximum distance that an RS-232 serial communication running at 9600 baud can travel on UTP CAT-5e? I have heard several different numbers, everything form 50' to 300'. Can anyone nail this down?

9 replies

by timwalsh

I'm unsure of what you are asking. How is the CAT-5e UTP being used in relation to the RS-232 serial device and what type of serial device are we talking here?

by jeremiah.prater

There is a DB-9 connector attached at each end, into which CAT5 UTP is plugged. The connector merely converts RJ-45 to DB-9

by dklippert

100 meters about 330 feet is the conservative estimate. It has been known to go 200 meters

by vinnyd

I have successfully wired dumb terminals on a unix system out to over 300 feet and run the terminals at 9600 baud.

But there are also rs-232 extenders that use regular rj-11 cable out to 800 meters that you can get.

by ciscoboy1

This question in really unanswerable as is.

What devices are on each end?
What protocol(s) are you running?

The Cat5 is not really the issue nearly as much as the devices. Different serial devices will have different distances they can transmit. (power output) You can have Short Haul modems in the mix and carry the signal over a mile.

The ranges you were told are probably true for the person's expirience who answered them.

So your distance can be from 50' to over a mile. :-)

This discussion is closed to new replies.