Discussion Locked

MBR messed up

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a compaq presario with a 60gig hard drive, I partitioned it with partition magic v.6, win me on C drive and win 2000 on D drive. Norton Systems works pro poped up and told me that my MBR had changed, out of the 3 possibilities to choose from I choose to save the MBR. after that I could no longer boot to drive C, so I used norton rescue disk to restore my MBR and now I can not see my drive D with win 2000, To fix this can I just boot from a start up floopy go to fdisk and format my D drive then start all over with partition magic from square one with out losing any thing on my C drive. Hope I can get some help here as I am just starting in this business, and have a lot to learn. Thanks.

7 replies

by dmiles

If you re-format the drive you will lose all data on the drive
In Win2K,use the setup disk and when prompted select to do a repair install and all the data may be saved
The other option would be to use the startup disk and use safe mode,and then select to boot to last known good configuration

by llbrink

I didn't realize that if I couldn't see the partition that I would be able to fix it with the set-up disk. Thank You.

by hanitech

you can try boot magic rescue disk which can be created from partition magic software and find out the missing 2000 or any other existing O/S

by llbrink

Good thing I asked this question, another answer that I never thought of. Thanks.

by scottsman

if the format is FAT32 you can try booting from floppy and at a: type: fdisk /mbr

sometimes this works sometimes this frags the whole this. use as a last resort.

do NOT try this if the drive is NTFS format

This discussion is closed to new replies.