Discussion Locked

Memory Burnout

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed some VeriTech 512m DDR 400 RAM. I then installed it (correctly) and started computer. Noticed that there was a plastic burning smell. No screen display. Turned pc off. Looked at Memory, realised that it had burn mark on it and the DIMM Slot. Got new Ram. installed it into second slot and nothing happens on reboot. Placed in third slot and again nothing. wonderirng if my GA-8ST 667 Gigabyte Mainboard is not compliant with 400mhz RAM. I would of thought it would of slowed ram down not burn it. Tech says the voltage is same on both 333 and 400mhz ram and couldn't be the result of non-compliance with mainboard. would I need to get a new mainboard? if so what would be compatable with socket 478 1.7gHz P4 Pentium Chip?

Any Help is appreciated..
Thanks,
Goncalo, gonz0@email.com :-)

2 replies

by jamesrl

a different way a few months back. My concern was that my older PCs DDR spec was much slower than some RAM I found at a very attractive price. I was worried about timing, and was universally told that there would be no issue.

And in fact there was no issue with "faster" RAM in my older PC.

I think even if there was a timing issue, you wouldn't necessarily get that burning plastic smell. I remember in the old days, when you had mismatched RAM, you may have a boot problem, but the computer wouldn't start, you pop in the right RAM and voila, you are back in business.

If you smell burning plastic, its possible that you have a capacitor or resistor thats fried, and that resulted in "higher" voltage going to the RAM slot, and frying your RAM.

James

by sdnetcom

What type of P4 chip do you have? I found a good motherboard that will support the P4 (Northwood/Prescott/P4 Extreme Edition (Socket 478), it is an MSI board which is a very good manufacture for MB's. I only use ASUS or MSI MB's for customers PC's, they're the only ones I trust and they have an impressive warranty and product support. As far as memory, I prefer to use SuperTalent memory. You can purchase a PC3200 DDR-400Mhz stick of 512Mb for about $69, it comes with a lifetime support and already installed heat speaders. It's a great value for ram these days. I'll send you a link for the MB if you would like, anything else I can help you with, just ask, always available..

This discussion is closed to new replies.