Discussion Locked

Memory Error with Asus MB!!

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Please help me figure this out.....
I have a new ASUS p3v4x MB and am trying to add new memory.....
I originally had 2 128mb pc 133 chips installed (Bank 0,1)and now just bought and trying to install a 256mb 133!
I originally put the 256 first (bank0)since i thought it would be best...The 256 worked byitself in slot 1....... then i installed the other two 128mb in slots 2,3 and the bios & post seen all the memory but when i used Norton to test it gave me erros within the first bank 261xxxxxxxxxx!
Now i just tried the original 2 128's back in slots 1,2 and another 128 in slot 3, and that did not even work--error at 193xxxxxxxx! I thought maybe this last 128 was pc100 and even placed it first!! Still not working..
I just bought the 256 and 128 from tiger 1 week ago and both are marked pc133.... I installed these in slots 1,2 reversed them and still not working together!!!
I have FULLY cleaned and aired out the slots and even with a small brush 4 times! the MB is very clean and dust free already!
Individually all these chips work perfect but apparently not together...The manual for the MB says I can mix any combination of RAM from 8 to 512 in ea slot(2GB max)....it doesnt say anything about having them in pairs?? Also theBios seems to be the most up to date......Please help me with this!!!@@#@!

6 replies

by q2ggirl

On the Monthly Technical Column on ASUS' web site, someone asked about a memory problem and the solution was a jumper change as well as BIOS update. You may be able to find your specific MB model to see if this will apply to you.

Another scenario, the memory you ordered from Tiger could be EDO memory. And you motherboard takes non-EDO memory. Then again, you could have been sent a bad DIMM.

Hope this gives you some more ideas...

by vtecaccord96

went to site no info on my board...clld tech support who says the mem is not compatible...prob was norton the whole time! same mem now works fine

by b_pope

there is nothing wrong with your memory.Norton's memory tester is unable to test memory above 256megs,without causing errors.If you go to
http://www.symantec.com/region/can/eng/
click on service & support ,when you get to thier knowledge base type in Norton diagnostic the article will be first on the list.
I HAD SAME PROBLEM

by b_pope

after clicking on support you click on, I am a home /small business user,you have to put in your version of systen works,dont put in utilities

by vtecaccord96

Thanks spyperdog!!!! This seemed to be the prob! ... I did their vcache "fix" and got it to test up to 384MB successfully! However it still wont test the 512! Ill look for another mem tester to use for now....

This discussion is closed to new replies.