9 replies
by mkh121
you Can't add SDRAM PC133 memory to any motherboard with 100mhz external system bus that now You Have one dimm of SDRAM PC100.
a few of "new motherboard" can complex 100Mhz and 133Mhz sdRam.
if you tell about motherboard mark I can actually answer you.
I hope this help you!
by jmdelaf
by dmiles
You will not be to mix the PC 133 memory on a 100 mhz bus,it may cause your computer to lock up or corrupt data
66mhz and 100mhz memory can be mixed if supported by the board.
by jmdelaf
by fred_e944
Maybe.
If the SDRAM has Serial Presence Detect it should coexist with other memory. I have run a PC-100 board (Asus P5S-B) with 2 64 MB DIMMs, 1 a PC-100 and the other a PC-133. The SPD reads incoming clock & timing (RAS, CAS) signals then setsthe DIMM to match the bus speed.
by jmdelaf
by xtrapollis
In most cases, it will work absolutely fine. In other cases, it just won't boot, but you will have zero damage or data loss. In fact, the odds of it not working are almost the same if you stick PC-100 in there (yes PC-100 doesn't always work on a 100MHz system for various stupid reasons.) Note that there are just a few motherboards that require very specific memory, which is often detected by the SPD on the RAM.
PC-133 just means the memory is rated to run at 133MHz. Architecturally it is the same for all practical explanations. It will always run at a lower speed. i.e. 100MHz.
Sometimes you get weird timing issues such as the actual CAS latency changes when you run memory at different speeds and so on. However, in my experience PC-133 performed just as well if not better than PC-100 on all PC-100 systems that I used it on, but then we get into the mixing and matching issue.
Most often mixed RAM works. However, it is best to use the same speed (100/133), brand, CAS rating (2/3), and other timings (7.5ns/8.0ns/10.0ns/etc.) On systems with less than 600MHz CPUs this is not as important, but on faster systems this becomes more important. In the faster cases, you not only want matched RAM if possible, but you also want the fastest--133MHz/222/7.0ns/5.4ns or better RAM because in my case, for example, this means a 10% difference in overall performance.
There is a lot more to RAM, but if you just look for these few things, you'll get what you need:
1. PC-100 or PC-133
2. CAS 2 or 3 - for many people this makes little difference, but get 2 if you can because it is faster
3. nanosecond rating - Don't get slower than 8.0ns because it makes a huge difference. If you got below a 600MHz or so, up to 10.0ns isn't really too bad though. At todays RAM costs, shoot for 7.5ns or < because it is not as expensive as it used to be.
by jmdelaf
by jmdelaf
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending