Discussion Locked

memory replacement in w2k server

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can you use a pc 133 memory card on a mother bd that has pc 100.. Im not sure what is in pc now.. thanls

7 replies

by hrhold1

All memory is 'backward' compatible, the question is " will the server MB recognize it?" You can install PC133 dimm on a 100Mhz board, if your bios can be set to accept PC133 mem you should be alright, if not, once installed you may get a few annoying 'page faults'. If you do you may want to put PC100 back in it, it's usually the same price anyway.

Hope this helps .... H

by csmith

The slower memory has to be in Bank 0,
(The first bank.) because some BIOSs only detect speed off of the first bank.
The PC's memory system bus can only run as fast as the slowest memory, so if you mix 100 and 133, the bus can only run at 100, andremain stable.
If you can, consolidate the 100 memory in one PC, and run only 133 in the other. That way you can take advantage of the 133. (Assuming the PC Motherboard can go to a 133MHz bus.)
Regards, Chris

by dcosgrove

One other thing to consider, depending on what type of server, you may have registered ECC memory.

This discussion is closed to new replies.