Discussion Locked

memoryupgrade

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
NEED SOME HELP IN LOCATING WHERE THE NEW MODEMS GO. DO NOT HAVE MANUAL. ITS A PACKARDBELL PLT1 COMPUTER, PLEASE HELP. THANK YOU

6 replies

by bill_w

Do you mean "where the new modules go"? That is, is this for a RAM upgrade? In any event, it depends on what is already there. And have you checked HP's site for the motherboard layout for the PLT1? Must admit, HP site is good for printers, but not so sharp for PCs. Anyway, sounds like the motherboard may be full, ie have all RAM slots used, if the empty slots are not obvious.

by bill_w

Oops, Barmaley, HP for PB? I must be slipping! To confuse the issue even more, if the PC is a 486, it could have the older 30-pin SIMMs, and some mid-speed Pentium boards can take both the 72-pin SIMMs, or newer 168-pin SDRAM (but usually not both). Anyway, the site (via Google search): http://www.memoryx.net/pacbelplatpl.html
has details - takes 4 72s (in pairs), 32Mb max each, 128 max total.

by barmaley

First, "99100MoreFM", I don't think you'll find Packard Bell infon on Hewlett Packard website.
Second, there are a lot things to concider.
You didn't give us enough info to help you.
If it is older system (for ex. Pentium 100) it could be 72 pin sticks
If it is fresher than that it could be SDRAM PC-66 or PC-100 or PC-133 (168 pin)
Best way would be to put same speed memory as MB specs.
In lot of cases you can put PC-133 into PC-100 and sometimes to PC-66
Another thing to consider is memory dencity.
some older computer (MB) will not recognize 8 chip memory and will recognize 16 chip sticks

This discussion is closed to new replies.